- The earth's lithosphere is cracked into a number of large rigid slabs called plates. Where these plates meet is
the plate boundary.
- The plates move, floating on the soft rock, beneath the lithosphere.
- Some plates carry just ocean basin but most have both continent and ocean basins.
- Plates can drift apart (through sea floor spreading), push into each other or slide past each other.
- Britain is on the Eurasian plate.
- Most earthquakes, volcanoes and mountain forming takes place at plate boundaries.
- The fastest plates e.g. Pacific Plates, move at over 10cm a year.
- The North American and Eurasian plates are among the slowest movers. New York and London are moving apart by
between 5-10cm each year.
- One method of measuring plate speed uses laser beams bounced off a satellite.
- Stripes of opposite magnetization occur in the ocean basins because periodically the earth's magnetic North
Pole flips south and Earth's magnetic field switches direction. Basalt in the ocean basins records this because
it contains iron compounds, which follow the magnetic field. The stripes exist because new basalt forms and
pushes old basalt out. The discovery of stripes confirms that sea floor spreading is taking place.
- Why do plates move? Hot, soft rock, is less dense than other rock so it rises to the earth's surface causing
convection currents. This soft rock is then forced sideways when it hits the plates. As it is pushed sideways,
it drags the plates along. As the magma cools near the surface, it melts again and this occurs over and over
again. The result is sea floor spreading.
- Radioactive materials within the Earth's crust act as a heat source to drive convection currents.
- Along the mid Atlantic ridge, there are diverging plates (North American and Eurasian). There are many
earthquakes along the ridge. They are moving apart and therefore creating new land. This is called a
Formation of a Fault:
- A fault occurs when a rock is put under enough pressure and cracks. The fault is the movement of the rock that
has been broken away. There are different types of fault when the direction of movement is different. When a
rock is under enough stress, it stores some of the energy as strain energy. When this energy is released, it
causes an earthquake.
Formation of Folds:
- Folds are formed when compressed rock deforms but unlike faults, it does not crack. Folding normally takes
place on the boundary between two converging plates.
Formation of Fold Mountains:
- Mountains usually start as sedimentary rock on the bottom of the sea. This is then squashed upwards by
converging continental plates. It then got folded, faulted, metamorphosed, and intruded by igneous plutons.
Formation of Volcanoes:
- Underwater volcanoes erupt a lot at diverging boundaries. Subduction (The driving down below of the thinner
denser ocean plate below the thicker continental plate) at ocean trenches also leads to earthquakes as it is
heated and softened as it rubs against the other plate. The water is superheated and causes melting and a